Sanden SD-508 Air Cond Compressor R12

Rear Axle Shaft Removal

The rear axle shaft must be disconnected from the differential housing before the differential carrier can be removed. A slide hammer is required to withdraw the axle together with the brake back plate as a unit as shown above.

Vital Jacking Points at High

                                    Vital and Safety Jack Up points prior to clutch removal and replacement incl. Rear Differential Carrier Unit at the Back. Note: the wheel lugs at the back are loose awaiting for disconnection of the rear driveshaft in order that the Rear Differential Carrier can be removed.

Reprogramming new transmitter unit to the Car

If two units of Central Door Lock control transmitter unit are bought ( M2) you need to register it with the receiver unit in the car as follows:

1. Insert the key into the ign switch key cylinder.
2. Turn the key to ON and OFF 5 TIMES IN A ROW with the ign key resting on the ON position.
3. There will be 1 or 2 beep indicating it is open for registration.
4. Press the button at the transmitter unit twice.
5. There will be 1 or 2 beep indicating it is registered. ( if only one transmitter unit jump to point 8 below)
6. Press the button of the second transmitter unit twice.
7. There will be 1 or 2 beeps indicating that this too has been registered.
8. Switch off the ign key and remove it.
9. Close the door and use the remote transmitter central door locking unit to unlock and lock the doors to confirm.